Soundoff-signal Predator 2 DDG User Manual download pdf

EP2SGS1(x) 02/08

WARNING: Warning devices are strictly

regulated and governed by Federal, State and

Municipal ordinances. These devices shall be

used ONLY on approved vehicles. It is the sole

responsibility of the user of these devices to

ensure compliance.

SINGLE EXTERIOR DECK / GRILLE

WARNING SYSTEM

ASSEMBLY INSTRUCTIONS

EP2SGS1(x)

BRACKET MOUNTING

Important: DO NOT over tighten

mounting screws or nuts. This could

cause permanent damage to the bracket

1. Locate flat mounting location for

Predator II Light Bracket.

2. When position of bracket is determined

use supplied template for hole

locations.

3. Drive in Customer Supplied Hex Head

screws. Leave about a 1/16” space

between the mounting surface and

underside of screw head.

4. Place Light over screws using the

holes in brackets and slide to the right

to lock the brackets underneath the

head of the bolts.

5. Using a open-end wrench, tighten the

hex head bolts down tight to secure

the light to the mounting surface.

6. Adjust angle of the light to best suit

your application by loosening the 2

nuts on either end of the light.

7. After the Predator is set to the desired

angle, tighten the 2 nuts on either end

of the light. DO NOT OVER TIGHTEN

nuts as damage to bracket or light can

occur. Tighten nut until snug plus 1/8

turn.

8. Make electrical connections using the

following instructions.

WARNING

This product contains high intensity LED

devices. To prevent eye damage, DO NOT

stare into light beam at close range.

NOTE: The PREDATOR II is a factory

sealed unit that CANNOT be serviced

in the field. Any attempt to gain

access to the PREDATOR II unit will

most likely cause permanent damage

and void its warranty.

IMPORTANT: DO NOT connect this

device to a strobe power supply.

OPERATING INSTRUCTIONS

See setup procedure on second page.

The single Predator II comes equipped

with an internal flasher with 33 user

selectable patterns that can be

synchronized either alternating or

simultaneous with up to three other lights.

It can also be put into slave mode and

driven through an external flasher.

1. Connect the PREDATOR II BLACK wire

to a good, convenient ground.

2. Connect the PREDATOR II RED wire to

one side of a user supplied on/off switch.

Connect the other side of the switch,

through a 5Amp fuse, to a source of

+10-30Vdc.

Install Screws (user supplied)

first using template on back

Place Light over screws using keyway in brackets

Slide Light to the Right and tighten screws using box end wrench

SCREW PLACEMENT DRILL TEMPLATE

(Be sure to use appropriate drill size for your screw size)

2.77

1 2

Summary of Contents

Page 1 - WARNING SYSTEM

EP2SGS1(x) 02/08WARNING: Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used

Page 2

! WARNINGThis product contains high intensity LED devices. To prevent eye damage, DO NOT stare into light beam at close range.EP2DGS1(x) 02/08SIN

Comments to this Manuals

No comments

Soundoff-signal Predator 2 DDG User Manual

Browse online or download User Manual for Lighting Soundoff-signal Predator 2 DDG. SoundOff Signal Predator 2 DDG User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Soundoff-signal Predator 2 DDG