Soundoff-signal LED3 Surface Mount (10-30v) User Manual download pdf

2x Supplied

#6 x 3/4” Sheet metal Screws

Supplied Gasket

EL3SN30(x) 4.10

WARNING: Warning devices are strictly

regulated and governed by Federal, State and

Municipal ordinances. These devices shall be

used ONLY on approved vehicles. It is the sole

responsibility of the user of these devices to

ensure compliance.

SINGLE EXTERIOR

LED3 WARNING LIGHT

ASSEMBLY INSTRUCTIONS

EL3SN30(x)

WARNING

This product contains high intensity LED

devices. To prevent eye damage, DO NOT

stare into light beam at close range.

MOUNTING

Important: DO NOT over tighten

mounting screws or nuts. This could

cause permanent damage to the light.

1. Locate flat mounting location for the

LED3 Light.

2. When the position of LED3 is

determined use paper template on

next page to drill hole locations. Screw

mounting holes should be drilled using

a 3/32” drill bit. Wire entry holes

should be drilled using a 1/4” drill bit.

3. Make electrical connections.

4. Using supplied #6 x 3/4” screws, fasten

LED3 to mounting surface. Be sure

not to overtighten screws as this will

cause hole in mounting surface to strip

out. Be sure that supplied gasket is

mounted between mounting surface

and LED3.

NOTE: The LED3 is a factory sealed unit that

CANNOT be serviced in the field. Any

attempt to gain access to the LED3 unit

will most likely cause permanent damage

and void its warranty.

IMPORTANT: DO NOT connect this

device to a strobe power supply.

OPERATING INSTRUCTIONS

See Configuration Instructions.

The single LED3 comes equipped with an

internal flasher with 33 user selectable

patterns that can be synchronized either

alternating or simultaneous with up to

three other lights. It can also be put into

slave mode and driven through an

external flasher.

1. Connect the LED3 BLACK wire to a good,

convenient ground.

2. Connect the LED3 RED wire to one side

of a user supplied on/off switch. Connect

the other side of the switch, through a

5Amp fuse, to a source of +10-30Vdc.

2.5"W x 1.375"H x 1.25"D

10-30Vdc

0.5 Amps*

Yes

-40º to +65º C

*Pattern Dependent

TECHNICAL SPECIFICATIONS

Overall Dimensions:

Flash Patterns:

Input Voltage:

Current Consumption:

Light Sync Technology:

Operating Temperature:

2.21

1.085

1/4” DRILL

1.480.73

2xØ3/32”

Drill Template for Mounting Holes/Cord Entry

Template Shown Actual Size

1 2

SINGLE EXTERIOR 1
LED3 WARNING LIGHT 1

Summary of Contents

Page 1 - LED3 WARNING LIGHT

2x Supplied #6 x 3/4” Sheet metal ScrewsSupplied GasketEL3SN30(x) 4.10WARNING: Warning devices are strictly regulated and governed by Federal, State

Page 2

EL3SN30(x) 4.10FLASH PATTERNS forSINGLE HEAD EXTERIOR LED3 (EL3SN(x))X-Pattern SequenceID#1 > ID#4 > ID#2 > ID#3X-Pattern Light Head Placem

Comments to this Manuals

No comments

Soundoff-signal LED3 Surface Mount (10-30v) User Manual

Browse online or download User Manual for Lighting Soundoff-signal LED3 Surface Mount (10-30v). SoundOff Signal LED3 Surface Mount (10-30v) User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Soundoff-signal LED3 Surface Mount (10-30v)