Soundoff-signal nFORCE Interior User Manual download pdf

IMPORTANT INFORMATION:

Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.

To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/sales-support.

If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).

Questions or comments that do not require immediate attention may be emailed to [email protected].

SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.

nFORCE LED Interior Lightbar

ENFWBF(xx)0(x) 5.14

WARNING

This product contains high intensity LED devices. To

prevent eye damage, DO NOT stare into the light

beam at close range.

1.800.338.7337 / www.soundoffsignal.com

TABLE OF CONTENTS

PAGE CONTENT

1 COMPONENTS/ CONTENTS

2 TECHNICAL/ POWER SPECIFICATIONS

3-7 ELECTRICAL INSTALLATION

8 CONTROL HARNESS

9 LIGHT MODULE WIRE HARNESS LOCATIONS &

DRIVER MODULE REPLACEMENT

10 NFORCE TROUBLESHOOTING

11 CONNECTION OF BREAKOUT BOX TO SOUNDOFF

SIGNAL SIRENS

12 REPLACEMENT PARTS

13 WARRANTY AND RETURN GOODS PROCEDURE

• Warning devices are strictly regulated and governed by Federal, State

and Municipal ordinances. These devices shall be used ONLY on approved

vehicles. It is the sole responsibility of the user of these devices to ensure

compliance.

• DO NOT install this product or route any wires in the Air Bag Deployment

Zone. Refer to your vehicle Owner’s Manual for the location of any air

bag deployment zones.

• DO NOT connect this device to a strobe power supply. This product is

self-contained and does not require an external power supply.

Important Information:

IMPORTANT NOTICE TO INSTALLER: Make sure to read and understand

all instructions and warnings before proceeding with the installation of this

product. Ensure that the manual and any warning cards are delivered to the

end user of this equipment. Proper installation of the lightbar requires the

installer to have a thorough knowledge of automotive electronics, systems,

and procedures. Lightbars provide an essential function of an effective visual

warning system. The use of the lightbar does not insure that all drivers can

or will abide by or react to an emergency warning signal, especially at high

rates of speeds or long distances. The operator of the vehicle must never take

the right of way for granted and it is the operator’s responsibility to proceed

safely. The effectiveness of the lightbar is highly dependant on the correct

mounting and wiring. The installer must read and follow the manufacturer’s

installation instructions and warnings in the manual. The vehicle operator

should verify daily that the lightbar is securely fastened to the vehicle and

properly functioning before operating vehicle. The lightbar is intended for use

by authorized personnel only. It is the user’s responsibility to ensure they

understand and operate the emergency warning devices in compliance with

the applicable city, state and federal laws and regulations. SoundOff Signal

assumes no liability for any loss resulting from the use of this warning device.

Components/Contents

Standard Equipment:

1 - nForce™ LED Interior Lightbar built to your speciﬁcations

1 - Breakout Box

1 - 24 Pin Harness

1 - Mounting Hardware

Unpack Lightbar

1. Remove the lightbar from box and packaging.

2. Save packaging for later shipping.

3. Check components/contents.

4. Please reference these instructions for proper wiring and installation.

1 2 3 4 5 6 ... 12 13